Electrolux EI30BM60MS User Manual

Page 6

Advertising
background image

PLACEMENT OF THE MOUNTING PLATE

1

Installation Instructions

Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which

locates nails.

B. Use a hammer to tap lightly across the

mounting surface to find a solid sound.
This will indicate a stud location.

After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16

w (40.6 cm) or 24w (61 cm) from this mark.

Draw a line down the center of the studs.

THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.

1

Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.

REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE

FINDING THE WALL STUDS

B

.

A

.

2

Wall
Studs

Center

3

Carton

Pull the carton up and off the oven.

2

Styrofoam

3

1

Screws

Screws

Mounting Plate

5

4 Cut the middle of the outer protective plastic bag to

remove the

ounting late

m

p

Turntable
glass tray

Exhaust Adapter

Small Hardware Bag

Glass Tray

Shelf

Remove the installation instructions,use and care,

exhaust adapter, turntable ring, shelf , glass
tray and the small hardware bag. Do not remove

the Styrofoam protecting the front of the oven.

where they were removed.

Remove the screws from each end of the mounting
plate. This plate will be used as the rear wall template
and for mounting. Reinstall the screws into the holes

Ring below

EN-6

Advertising