Acer PCI Disk Array Controller Drivers 08P4100 - Manual (Page 23)

NetWare
Manual No. 775079 2-9
2
N
E
T
W
A
R
E
1. The appropriate drivers should be loaded before trying to access the
non-disk devices.
2. Load the following drivers to use a CD-ROM under NetWare 5.0
(cdrom is supplied by Novell):
☛
Note
mdac.ham and scsicd.cdm are usually loaded in the
startup.ncf file.
: load mdac.ham
: load scsicd.cdm
: load cdrom
After the CD-ROM is mounted, the volume on the CD-ROM can be
mapped from any workstation and accessed.
Installing the Mylex Disk Array Controller into an Existing
NetWare 5.0 System
If NetWare 5.0 is already installed and you wish to add a Mylex Disk Array
Controller later, the controller will be a secondary (non-bootable) controller.
After installing the controller hardware and configuring a disk array, follow
the procedure below to add the necessary controller drivers.
1. Copy NWASPI.CDM (for GAM support).
• Copy C:\NWSERVER\DRIVERS\NWASPI.CDM to the directory
named, C:\NWSERVER.
• In the C:\NWSERVER\STARTUP.NCF file add LOAD
NWASPI.CDM with the other LOAD XXXX.CDM
2. With NetWare Server 5.0 loaded and running, load the NetWare
program by typing the following at the console prompt:
: load nwconfig
and press <Enter>.
3. Choose “Driver Options” in the Installation Options menu.
4. Choose “Configure disk and storage device drivers” in the Driver
Options menu.
5. Choose “Select an additional driver” in the Additional Driver Actions
menu.