Water Inc HP-Soft-4 - Manual (Page 3)

Important Safety Information – Read All
Instructions Before Using
CAUTION: Read and follow the information in this manual to
minimize the risk of electric shock or personal injury.
IMPORTANT! If you are unsure about installing of your water
softener, contact the helpline or consult a professional plumber.
IMPORTANT! This system must be installed in compliance with
applicable state and local codes, law, and regulations.
!

Before beginning installation, read these all instructions completely. Then obtain all the materials and
tools needed for installation.
NOTE: Failure to install the HousePure Soft system correctly voids the warranty.

Perform installation according to state and local plumbing codes.
- Use only lead-free solder and flux for sweat-solder connections, as required by state and
federal codes.

Handle all components of the system with care. Do not drop, drag or turn components upside down.

Be sure the floor under the water softening system is clean and level.

The system uses 120 volt-60Hz electrical power. Always use the power cord supplied.
- Plug power cord into an indoor 120 volt, grounded outlet.
- Properly ground system to conform to all codes and ordinances.

Install system in a protected area. Be sure electric outlet and transformer do not come in contact with
water. See Where to Install the Softener, in the installation section of the manual.
-
Do not attempt to treat water over 110°F with the system. Always connect the system to the
main water supply pipe
before the water heater.
- Do not expose system to freezing temperatures. Water freezing in the system causes
equipment damage.
- Do not install in direct sunlight. Heat from sun may cause damage.

Minimum inlet water pressure is 20 psi. Maximum inlet water pressure is 125 psi. Use pressure
reducing valve if necessary.

Sodium used in the water softening process should be considered as part of your overall dietary salt
intake. Contact physician if you are on a low sodium diet.

Use clean water softening salts only, at least 99.5% pure. Failure to use the correct salt may create a
health hazard or maintenance problems.
-
Use nugget, pellet or coarse solar salts.
- Do not use rock, block, granulated or ice cream making salts.

Always keep the salt lid in place unless servicing the unit or replenishing salt.
!
CAUTION:
 Do not use with water that is unsafe or of unknown quality.
 Test water periodically to verify that the system is performing
satisfactorily.
 Discard small parts remaining after the installation.