Water Inc HP-Soft-4 - Manual (Page 5)

Setup
Unpacking and Inspection
Check the system components for damage or missing parts.
Where to Install the Softener
Consider the following points when determining where to install the water softener:
 Place
the system as close as possible to a sewer drain.
 Do not install the softener where it would block access to the water heater, or access to the main water shutoff,
water meter, or electrical panels.
 Keep outside faucets on hard water to save soft water and salt.
 Install the softener in a place where water damage is least likely to occur if a leak develops.
 A 120V electrical outlet is needed to plug in the transformer. If the outlet is remote (up to 100 feet), use 18 gauge
wire to connect.
 Always connect the system to the main water supply pipe before the water heater.
 Install
the system where it will not be subject to temperatures outside of the limits stated in the Specification
section or to direct sunlight.
Hardness Setting
Municipal Water:
Water, Inc. recommends that you call your local water company to determine your water hardness in grains per
gallon and iron in mg/l (or ppm).
Well Water:
Water, Inc. recommends that you have your water tested professionally for accurate hardness and iron content.