Asus K8N-DL - Manual (Page 103)

A S U S K 8 N - D L A S U S K 8 N - D L A S U S K 8 N - D L A S U S K 8 N - D L A S U S K 8 N - D L 4 - 4 1 4 - 4 1 4 - 4 1 4 - 4 1 4 - 4 1
4.6.4 4.6.4 4.6.4 4.6.4 4.6.4 Boot Settings Configuration Boot Settings Configuration Boot Settings Configuration Boot Settings Configuration Boot Settings Configuration
Select Menu
Item Specific Help
Select your boot device
priority.
Boot Settings Configuration
Boot Other Device [Enabled]
Quick Power On Self Test [Enabled]
Halt On [All, But Keyboard]
Boot Up Floppy Seek [Disabled]
Boot Up NumLock Status [On]
Typematic Rate Setting [Disabled]
Typematic Rate (Chars/Sec) 6
Typematic Delay (Msec) 250
Boot Other Device [Enabled] Boot Other Device [Enabled] Boot Other Device [Enabled] Boot Other Device [Enabled] Boot Other Device [Enabled]
Allows you to enable or disable selection of other boot device.
Configuration options: [Disabled] [Enabled]
Quick Power On Self Test [Enabled] Quick Power On Self Test [Enabled] Quick Power On Self Test [Enabled] Quick Power On Self Test [Enabled] Quick Power On Self Test [Enabled]
This field speeds up the Power-On-Self Test (POST) routine by skipping
certain tests while booting, thereby decreasing the boot time.
Configuration options: [Disabled] [Enabled]
Halt On [All, But Keyboard] Halt On [All, But Keyboard] Halt On [All, But Keyboard] Halt On [All, But Keyboard] Halt On [All, But Keyboard]
Sets the system to halt on errors according to the system functions
specified in each option. Configuration options: [All Errors] [No Errors]
[All, But Keyboard] [All , But Diskette] [All, But Disk/Key]
Boot Up Floppy Seek [Disabled] Boot Up Floppy Seek [Disabled] Boot Up Floppy Seek [Disabled] Boot Up Floppy Seek [Disabled] Boot Up Floppy Seek [Disabled]
When enabled, the BIOS will seek the floppy disk drive to determine
whether the drive has 40 or 80 tracks. Configuration options: [Disabled]
[Enabled]
Boot Up NumLock Status [On] Boot Up NumLock Status [On] Boot Up NumLock Status [On] Boot Up NumLock Status [On] Boot Up NumLock Status [On]
Allows you to select the power-on state for the NumLock. Configuration
options: [On] [Off]