Asus K8N-DL - Manual (Page 85)

A S U S K 8 N - D L A S U S K 8 N - D L A S U S K 8 N - D L A S U S K 8 N - D L A S U S K 8 N - D L 4 - 2 3 4 - 2 3 4 - 2 3 4 - 2 3 4 - 2 3
Chip-Kill Mode Enable [Disabled] Chip-Kill Mode Enable [Disabled] Chip-Kill Mode Enable [Disabled] Chip-Kill Mode Enable [Disabled] Chip-Kill Mode Enable [Disabled]
When set to [Enabled], allows ECC checking to be based on a 128/16
data/ECC rather than on a 64/8 data/ECC. You may only enable this
feature in 128-bit DRAM data width mode. Configuration options:
[Disabled] [Enabled]
ECC Redirection [Disabled] ECC Redirection [Disabled] ECC Redirection [Disabled] ECC Redirection [Disabled] ECC Redirection [Disabled]
When set to [Enabled], correctable errors are corrected as the data is
passed to the requestor. The data in the DRAM is not corrected if this item
is set to [Disabled]. Configuration options: [Disabled] [Enabled]
DRAM Background Scrubber [Disabled] DRAM Background Scrubber [Disabled] DRAM Background Scrubber [Disabled] DRAM Background Scrubber [Disabled] DRAM Background Scrubber [Disabled]
Specifies the scrub rate of the next address to be scrubbed by the DRAM
scrubber. Configuration options: [Disabled] [40.0ns]
L2 Cache Background Scrubber [Disabled] L2 Cache Background Scrubber [Disabled] L2 Cache Background Scrubber [Disabled] L2 Cache Background Scrubber [Disabled] L2 Cache Background Scrubber [Disabled]
Specifies the scrub rate of the next address to be scrubbed by the L2
cache scrubber. Configuration options: [Disabled] [40.0ns]
DCache Background Scrubber [Disabled] DCache Background Scrubber [Disabled] DCache Background Scrubber [Disabled] DCache Background Scrubber [Disabled] DCache Background Scrubber [Disabled]
Specifies the scrub rate of the next address to be scrubbed by the data
cache scrubber. Configuration options: [Disabled] [40.0ns]
4.4.3 4.4.3 4.4.3 4.4.3 4.4.3 Chipset Chipset Chipset Chipset Chipset
This menu shows the chipset configuration settings. Select an item then
press <Enter> to display a pop-up menu with the configuration options.
Select Menu
Item Specific Help
Disable/Enable OnChip IDE
Channel0.
Chipset
OnChip IDE Channel0 [Enabled]
OnChip IDE Channel1 [Enabled]
Hyper Transport Frequency [4x]
Hyper Transport Width [
↓↓↓↓↓
16
↑↑↑↑↑
16]
Errata 94 Enhanced [Auto]
System BIOS Cacheable [Disabled]
Spread Spectrum [Enabled]
SATA Spread Spectrum [Disabled]
PCIE Spread Spectrum [Disabled]
SSE/SSE2 Instructions [Enabled]
Init Display First [PCI Slot]
IDE DMA Transfer Access [Enabled]
Serial-ATA 1 [Enabled]
SATA DMA Transfer [Enabled]
Serial-ATA 2 [Enabled]
SATA2 DMA Transfer [Enabled]
IDE Prefetch Mode [Enabled]