LG LFX25978ST - Manual (Page 13)

13
• Insert the water supply tube into the connector.
• Insert the tube at least 5/8 in. (15 mm) into the
connector.
• Hook the tab on the door-switch side of the cover
under the edge of the wire opening in the cabinet
top.
• Position the cover into place.
• Insert and tighten the cover screw.
CAUTION
1. Insert the tube until you can see only one of the lines
printed on the tube.
2. After inserting, pull the tube to ascertain that it is
secure.
3. Assemble the clip.
Correct
Incorrect
HOW TO REMOVE AND INSTALL THE PULL
OUT DRAWER (4 DOORS MODELS).
1. Removing Pull out Top Drawer
IMPORTANT: To avoid possible injury, product or
property damage, you will need two persons to
perform the following instructions.
• Pull the drawer open to full lower extension.
Remove the durabase by lifting it from rail system.
(Fig. 1)
Fig.1
• Remove the screws of the rail on both sides.
(Fig. 2)
Fig.2
CAUTION: When removing drawer door, do not
hold it by the handle. The door could fall down
and you may be injured. Grasp the door with both
hands as pictured below when removing.
CAUTION: When laying down the drawer, be
careful not to damage the floor or hurt your feet
with the sharp edges on hinge side.
• With both hands, hold both sides of the door
(Fig. 3) and pull it up to separate it from the rails.
Fig.3
Collet
Insert Line
Clip
Tube
REFRIGERATOR INSTALLATION
6
REFRIGERATOR INSTALLATION