LG LFX25978ST - Manual (Page 23)

23
SETTING THE FUNCTIONS
SETTING THE DISPENSER LOCK
Press and hold the
ALARM/LOCK button
for three seconds to lock
the dispenser and all of
the other control panel
functions.
Press and hold again for 3
seconds to unlock.
NOTE: The function lock in models without Energy
Saving do not lock water and Ice Switch.
SETTING THE DOOR ALARM
The ALARM/LOCK
button also controls the
door alarm that sounds
three times in 30-second
intervals when
a compartment door is left
open for more than 60
seconds. The alarm stops
sounding when the door is
closed.
Press the ALARM/LOCK button once to activate and
deactivate the door alarm function.
NOTE: Contact your local service center if the alarm
continues to sound after the doors are closed.
RESETTING THE FILTER INDICATOR
Press and hold the LIGHT/
FILTER button for more
than 3 seconds to reset
the filter indicator after
the water filter has been
replaced.
NOTE: It is recommended that the filter be replaced
when the indicator light on the front dispenser reaches
0. If the water or ice cube taste starts to deteriorates.
ACTIVATING ICE PLUS
Press the ICE PLUS/
*
ENERGY SAVING or ICE
PLUS button once to
activate the ICE PLUS
function. The ICE PLUS
icon on the display panel
will illuminate when
activated.
The ICE PLUS function
runs the freezer
compartment at the
coldest setting for a 24-
hour period to increase
icemaking by up to about
20%, and then turns off
automatically.
NOTE: Press the button again to deactivate the ICE
PLUS function.
*
ACTIVATING ENERGY SAVING
Press the ICE PLUS/
ENERGY SAVING button
for at least 3 seconds to
activate or deactivate the
function.
This function is
recommended for added
energy savings.
(Some heaters to reduce
excess moisture on the
refrigerator may be turned
off)
The energy saving function is also recommended
during long periods of time spent away from home-like
vacation.
DIAGNOSTIC FAILURE DETECTION
The diagnostic function automatically detects problems with your refrigerator, and a diagnostic code will appear in
the display. NOTE: If a diagnostic code appears in the display during use, note the code and call your Service Center.
Refer to the Warranty Card to obtain the telephone number of the Service Center near you.
*In some models it is not available the Energy Saving mode.
** The function of change to Fahrenheit just is available in models with Energy Saving mode.
USING YOUR REFRIGERATOR
or
USING YOUR REFRIGERATOR