Agilent Technologies J3972A - Manual (Page 49)

Local Terminal Configuration
Using a Local Terminal
29
Full/Half Press 8 and select the line type as Half-Duplex or Full-
Duplex Duplex. This parameter is not available unless the 10MB/s or
100MB/s option was selected for the Link Speed parameter.
Parameters do not take effect until you select the Save Changes and Exit
menu item.
3. Press S to save the configuration changes and return to the probe’s Main
Menu. If you want to cancel your current changes and return to the probe’s
Main Menu, press
0 .
Token-Ring Telemetry Interface Configuration
If the optional Token-Ring telemetry interface is not installed, skip this section
and continue with “OC-3 ATM Interface Configuration” on page 33. Otherwise,
use the following procedure to configure items in the Modify/View Interface
Values menu for the Token-Ring Telemetry Interface:
1. Press 3 to access the Modify/View interface values menu item. The
Modify/View Interface Values menu is displayed, as shown in Figure 2-6 on
page 30.