LG 22LG3DCH - Manual (Page 101)

COMMER
CIAL
MODE
SETUP
99
CLONING CONNECTIONS/TEACHING SETUP
Teaching the Master Setup to Another TV
Connections for the LT2002 to Teach another TV the Master Setup
QuickSet II Programmer
LT2002
• heartbeat power on communications ok
• slow power on
no communications
• green battery ok
• red battery low
Blink pattern
Color Reset
Status
Indicator
Connect cable to
TV MPI Jack and
follow on screen
instructions
MPI
Ferrite Core
(TDK, ZCAT
2035-0930)
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
Antenna
or CATV
Target TV
Clone Programmer
T Teeaacch h M Maasstteerr T TV V’’ss S Seettu up p tto o tth hee ttaarrg geett T TV V
After learning is complete, remove the M.P.I. cable from the mas-
ter TV and connect it to the target TV that you want to copy the
master TV’s setup into. With “THE CLONE HAS CONTROL OF
TV” message displayed, press 2 or use either Channel key to go
to the “TEACH TO TV” option, press ON/OFF, POWER, or
ENTER. Select the LT2002 memory that the new setup is in.
Press On/Off to transfer the new setup and other information to
the new TV. Teaching usually takes 2-3 minutes.
After the “TEACHING COMPLETE” message is displayed, press
any key to return to the Clone menu, then press ON/OFF,
POWER, or ENTER. If finished, detach M.P.I. cable from the
target, newly-cloned TV.
D Diisscco on nn neecctt T TV V P Po ow weerr ffo orr 1 15 5 S Seecco on nd dss
Unplug the AC power cord of the newly-cloned TV from the
power outlet for about 15 seconds to activate the newly-copied
setup.
TEACHING IN PROGRESS,
PLEASE WAIT
TEACHING COMPLETE
This display will appear after
Teaching is complete.
This display will appear dur-
ing Teaching function.
CLONE SELECTION MENU
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
-TO CHANGE MENU ITEMS, PRESS
CHANNEL KEYS OR DIGITS.
-TO EXECUTE ITEM, PRESS ON/OFF,
POWER, OR ENTER
This menu should appear after
any key is pressed on the Installer
remote.