LG 22LG3DCH - Manual (Page 115)

APPENDIX
113
REFERENCE: LT2002 CLONING PROCEDURE
TROUBLESHOOTING
32LG3DCH
(32LG3DCH-UA)
32LG3DC
(32LG3DC-UA)
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, use a paper clip or
similar instrument inserted through the small hole marked
”RESET” to activate the internal reset switch and restore
normal operation. After a reset, check the real-time clock
setting. It may be necessary to reset the Clone
Programmer clock from a TV containing the correct time.
Note
The LT2002 programmer is designed to be used with
TVs containing the 221-01006 and later processors. Use
with earlier TV sets may give unpredictable results.
Processors used before the 221-01006-04 have a limited
screen display capability. They cannot display entire
screens as shown in the quick setup instructions accom-
panying the LT2002 clone programmer. Use the printed
menu illustrations on the quick setup sheet supplied with
the Clone as an aid to making your programming choices.
(Although the menus are not all displayed, the clone
functions all operate normally.)
■ After cloning operations are complete, just unplug the LT2002 from the TV.
■ If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.
Clone Programmer Troubleshooting
Warning: Do not use LT2002 while any PPV card is
installed in TV or clone programmer will be damaged.
C Cllo on nee P Prro og grraam mm meerr
■ Press Reset on clone programmer, redo teach/learn. (Teach/Learn should take a
minimum of 1 minute.)
■ Only use an LG Installer remote to operate clone programmer with TV.
■ Connect M.P.I. cord properly, assure good connection.
■ TV must be powered On for clone to work.
■ Install 4 fresh AA high-quality alkaline batteries.
■ Connect TV to a reliable Analog channel signal source.
■ Set time on a TV, copy time to Clone Programmer.
■ Try a different LT2002 Clone programmer.
■ Reset Clone Programmer.
■ Retry cloning again.
Clone copies Setup in less
than 30 seconds
LED does not blink
Remote does not operate
clone
Clone menu hard to read
No time set
Clone not working
Clone Scans Channels
more than once
32LG3DCH
(32LG3DCH-UA)
32LG3DC
(32LG3DC-UA)
M Maasstteerr aan nd d O Otth heerr T TV Vss
■ Wait until procedure complete message is displayed.
■ Cloning is only possible with identical model TVs.
■ Reread cloning pages to be sure all tasks were performed.
■ Batteries must remain installed to retain time settings.
■ Disconnect newly-cloned TV from power for 5 seconds.
Cloning did not work
New Setup not present
Clone time disappeared