ADC P-80-412 - Manual (Page 2)

ADCP-80-412 N Issue 1 N April 2000
Page 2
© 2000, ADC Telecommunications, Inc.
An LED mounted on the Bay Tracer Electronic Sensor Device provides a large, bright, easily
observable, visual indication whenever an individual jack LED is activated on a DSX bay. This
allows a technician to identify the far end bay so that a scan can be performed to identify the
specific jack LED that has been activated. The indicator flashes for a nominal period of 70–90
seconds following jack activation to allow sufficient time to scan a 6
K 25 bay environment.
After the 70–90 second flashing cycle, the LED on the Bay Tracer Electronic Sensor Device is
extinguished and reset in preparation for the next tracer event. The individual DSX jack LED lit
by the activation flashes for 30 seconds and stays lit in a steady on state until a switch de-
activation occurs. Individual jack LEDs are not affected by Bay Tracer Illuminator operation.
Revision History
ISSUE DATE REASON FOR CHANGE
Issue 1 04/2000 Original
Trademark Information
ADC and ADC Telecommunications are registered trademarks of ADC Telecommunications, Inc.
Admonishments
Important safety admonishments are used throughout this manual to warn of possible hazards
to persons or equipment. An admonishment identifies a possible hazard and then explains
what may happen if the hazard is not avoided. The admonishments — in the form of Dangers,
Warnings, and Cautions — must be followed at all times. These warnings are flagged by use
of the triangular alert icon (seen below), and are listed in descending order of severity of
injury or damage and likelihood of occurrence.
Danger : Danger is used to indicate the presence of a hazard that will cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Warning : Warning is used to indicate the presence of a hazard that can cause severe
personal injury, death, or substantial property damage if the hazard is not avoided.
Caution : Caution is used to indicate the presence of a hazard that will or can cause minor
personal injury or property damage if the hazard is not avoided.
Certification
The product described in this manual has been tested and found to comply with the requirements
of UL 1863 and CSA C22.2 No. 225.