Alvarion BREEZENET RB-DS.11 - Manual (Page 40)

BreezeNET DS.11 Series User Manual
3-8
A VLAN Management Tag is inserted in all management frames generated
by the unit before transmission to either the Ethernet or wireless link port.
The tag includes the values of the VLAN ID Management and the VLAN
Priority Management parameters.
Operation with Management VLAN disabled (VLAN ID Management is 65535)):
The unit accepts only untagged management frames received on either the
Ethernet or wireless link ports.
Management frames generated by the unit are not tagged.
Valid values: 1 to 4094 or 65535 (No VLAN).
The default value is 65535 (No VLAN).
♦ VLAN Priority Management: When Management VLAN is enabled, a VLAN tag
is inserted in all management frames generated by the unit before transmission
to either the Ethernet or wireless link port. The tag includes the values of the
VLAN ID Management and the VLAN Priority Management parameters. The
VLAN Priority Management defines the value of the VLAN Priority field for these
tags. This parameter only impacts the way other VLAN aware devices handle
the frame.
Valid values range from 0 to 7.
The default value is 3 for both RBs and BUs.
♦ VLAN ID Access (BU only): The VLAN ID Access is the default VLAN ID for RBs
that are not included in the CPE Table (see below).
Valid values: 1 to 4094 or 65535 (No VLAN).
The default value is 65535 (No VLAN).
♦ VLAN Priority Access (BU only): The VLAN Priority Access is the default VLAN
Priority for RBs that are not included in the CPE Table (see below).
Valid values range from 0 to 7.
The default value is 3.
♦ 802.1Q Compatible (BU only): In SW version 4.1, encapsulation of tagged
frames transmitted on the wireless port was not compatible with the IEEE
802.1Q standard. The 802.1Q Compatible parameter enables choosing the
encapsulation method: 802.1Q compatible or DS.11 SW version 4.1
compatible.
When this parameter is disabled, encapsulation will be the same as in SW
version 4.1, providing compatibility with DS.11 RBs running SW version 4.1. In
this case there is no compatibility with other devices that are 802.1Q
compatible.
When this parameter is enabled, encapsulation will be in accordance with the
802.1Q standard. However, there will not be compatibility with DS.11 units
running SW version 4.1.
The default is Disable.