LG DLGX6002V - Manual (Page 29)

29
ENGLISH
HOW TO USE
4&-&$5
"
$:$-&
Scroll through the cycle screens, by either touching the arrow buttons or swiping the screen, and
select your desired cycle. Touch a cycle button to view its preset dry level, temperature, dry time,
and option settings.
HOW TO USE
BASIC OPERATION
#&(*/
$:$-&
Touch the START/PAUSE button to begin the cycle. The cycle can be paused at any time by
opening the door or by touching the START/PAUSE button. If the cycle is not restarted within four
minutes of being paused, the dryer will shut off and the settings will be lost.
&/%
0'
$:$-&
When the cycle is finished, the chime (if the volume is on) will sound and the Complete screen
will display. Immediately remove your clothing from the dryer to reduce wrinkling. If Wrinkle
Guard is selected, the dryer will tumble briefly every few minutes to help prevent wrinkles from
setting in the clothes for up to three hours or until the door is opened.
-0"%
5)&
%3:&3
Load the dryer with the wet laundry from the washer. If the load is extra large, you may need to
divide it into smaller loads for proper performance and fabric care. Be sure to remove items that
should not be dried in the dryer.
$-&"/
5)&
-*/5
'*-5&3
If the lint filter has not already been cleaned, lift out the filter and remove the lint from the last
load. This will help ensure the fastest and most efficient drying performance.
"%+645
$:$-&
4&55*/(4
"/%
4&-&$5
015*0/4
Default settings for the selected cycle can now be changed, if desired, using the cycle settings
and option buttons.
NOTE
Not all settings and options are available on all cycles.
563/
0/
5)&
%3:&3
Touch the POWER button to turn ON the dryer. The LG startup screen will display, followed by the
cycle screen.
NOTE
If power was interrupted, such as from a power outage, the control will take longer for it to
power up the first time after power is restored.
Approximately one minute after the power is shut off, the control enters standby mode. It
takes approximately four seconds for the control to power on from standby mode.