Acroprint ATR120 - Manual (Page 19)

15
IN2 In Punch (Lunch)
OUT2 Out Punch end of shift
IN3 In Punch Overtime Period
OUT3 Out Punch Overtime Period
· Select the column position by pressing button three. The column position icon
at the bottom of the display will stop flashing. ALL days of the week will
appear at the top of the display. To select this move everyday of the week
(recommended), press button six to select and to advance to the next column
selection.
· To select certain day(s) of the week, after pressing button three to select column
position (icon at bottom of display will stop flashing), press button two, and
SUNday icon will flash at top of display. Press button three to select that day.
Press button two to advance to the next day. Pressing button two without
pressing button three will skip that day of the week. Press button six to save
selections and advance to next event.
· To select the hour for the column change, press button four.
· To select the minutes for the column change, press button five.
· Remember to press button six to save and advance to the next programming
sequence. Each sequence is programmed the same way.
Selecting how the hour will print
The ATR120 will print hours in either 12- or 24-hour format.
· Press button one once. If you are entering the programming mode to adjust the
hour printing format, you will need to press button one nine times. The default
setting is 24H.
· Press button four to toggle between 12- and 24-hour printing format (12H and
24H). OUT3 flashes on the display.
· Press button six to save the hour printing format. OUT3 no longer flashes on
the display.