Acroprint ATR120 - Manual (Page 9)

5
clock to function as program switches. With the dust cover open you will find that
these program switches are numbered 1 – 6 to simplify programming the ATR120
The first switch on the top left of the clock (IN1) functions as the feature selection
switch and will advance you through the program mode. This switch also allows you
to skip over a feature and advance to the next feature without programming. Once a
feature is selected, switches “OUT2” through “IN3” will be used for programming.
We'll refer to the switches as buttons one through six.
The last switch on the right, button six or “OUT3” is used to save the program
selection to memory. IMPORTANT: If OUT3 is flashing in the lower right corner
of the display, the programmed changes have not been saved.
IN1
OUT1 IN2 OUT2 IN3 OUT3
O O O O O O
1 2 3 4 5 6
Select Save
ß-------------Programming Switches-------------à
(When in the PRO mode)
To return to the original factory settings press the “RESET” button located to the left
of the PRO/NOR switch on back of the clock.
Note: Each time you modify the program, you must press button six to save the
program changes. OUT3 flashes in the lower right corner of the digital display until
the programming change is saved. If OUT3 is flashing in the lower right corner of
the display, the program changes have not been saved.
Selecting day of week
The ATR120 can be programmed for either weekly or biweekly pay periods.
For weekly pay periods, program the time clock as follows:
· Enter the programming mode by setting the switch on the back of the
ATR120 to the PRO position. The display indicates 1-31.