LG LRV790R - Manual (Page 19)

17
HOW TO START AND STOP CLEANING
After the Hom Bot is turned on, press the START/STOP button to
begin cleaning. A melody will sound and cleaning will begin.
Press the START/STOP button during the cleaning cycle to stop
cleaning.
※ When the ‘START/STOP’ button is pressed while the Hom Bot is in
standby mode, it will turn on. Press the ‘START/STOP’ button one
more time to start cleaning.
After the Hom Bot is powered on, press the START button on the
remote control. A melody will sound and cleaning will begin.
Press the STOP button during the cleaning cycle to stop cleaning.
※ The Hom Bot cannot be turned on from standby mode by using
the remote control. When the power is off, press the ‘START/STOP’
button on the upper side of Hom Bot to turn the power on and to
allow the remote to be used.
※ During cleaning, collisions can happen when the sensor cannot detect certain objects (thin chairs and
table legs, furniture corners). When this happens, the internal impact detecting sensor will react by moving
the Hom Bot backwards.
※ If the Hom Bot is set to start cleaning at a location away from the home station, put the Hom Bot on a flat
floor in order to prevent a malfunction of the obstacle detecting sensor. In addition, start cleaning from a
location where there are no obstacles such as curtains or walls within 1 ft of the Hom Bot.
For best results:
• Briefly scan the area to be cleaned for big and small objects that will cause difficulty for the
Hom Bot.
• If cleaning is started when the Hom Bot is at the home station, the device can rapidly be
returned to the home station as the current home position has been accurately read.
• When the mop plate is installed, the Hom Bot will not go over door sills or other platforms of
0.196 in. or higher.
Using the buttons on the Hom Bot
Using the remote control
Tip