LG LRV790R - Manual (Page 30)

28
SMART DIAGNOSIS
1. Turn ON the Main Power Switch on the back after making
sure the Hom Bot is attached to the Home Station.
※ Smart Diagnosis is only possible when the Hom Bot is
attached to the Home Station.
2. Press 'Diagnosis' button on the Remote control, then
the process will start with a voice message which says
"Starting Hom Bot smart diagnosis. Please step away and
remove any items within 3 feet."
※ If the Mop Plate is attached, the process will not be
activated.
3. When the Smart Diagnosis has successfully
finished, Hom Bot will return back to the Home
Station and inform the result through a voice
message. After the voice message, pressing the
'HOME' button on the Remote control or main
unit will allow the voice message to be repeated.
To terminate the diagnosing process, press the
'Stop' button on the Remote control or main unit.
※ After the Smart Diagnosis voice message, the
Hom Bot will start recharging after 1minute.
※ If an error is detected with any of the Sensors
whilst in Smart Diagnosis, a voice message will
announce, and the unit will not return to the
home station.
Hom Bot uses the Smart Diagnosis feature to run self­diagnosis.
If any irregularity is found from the diagnosis, please contact the local LG Electronics
service center.
※ During Smart Diagnosis, the Hom Bot will move within a 1.64 ft radius. So, make sure no objects are in
the way within a 1 m radius around the Home Station, before starting Smart Diagnosis.
• Be careful not to touch the Hom Bot or disturb its operation before Smart Diagnosis is
complete. If it is accidently interrupted, turn the main power switch OFF then ON again to
resume the diagnosis.
• Smart Diagnosis will not be activated in each of the following cases. In each case, check the
problem and try again.
­ Hom Bot is detached from Home Station
­ Battery level is insufficient
­ No Dust Bin Filter is fitted.
­ Mop Plate is attached
Tip