ArcSoft Wing HERA110 - Manual (Page 184)

184 Getting Connected
Connect to other wireless networks
After Wi-Fi is turned on in Comm Manager, your device scans for available
wireless networks in your area.
To connect to a wireless network
1. The network names of the
detected wireless networks
will be displayed on a pop-
up message window. Tap the
desired wireless network, then
tap OK.
2. On the next pop-up message window, tap The Internet if the wireless
network connects your device to the Internet. Otherwise, tap Work if
the wireless network connects your device to a private network.
3. If the wireless network is secured by a network key, enter this key,
then tap Connect.
Next time you use your device to detect wireless networks, you will not see
the pop-up message windows again, and you will not be prompted to enter
the network key of the previously accessed wireless network (unless you
perform a hard reset which will erase custom settings on your device).
Note Wi-Fi networks are self-discoverable, which means no additional steps are
required for your device to connect to a Wi-Fi network. It may be necessary
to provide a username and password for certain closed wireless networks.