ArcSoft Wing HERA110 - Manual (Page 34)

34 Getting Started
To remove the battery and SIM card
1. Make sure your device is powered off.
2. Slide the back cover upward to release and remove the cover.
3. To remove the battery, lift it up from the end that is marked with a
REMOVE arrow symbol.
REMOVE arrow symbol
4. To remove the SIM card, unlock the SIM card slot first by pulling
the SIM card latch downward. Slide the SIM card towards the left to
remove it.
Charge the battery
New batteries are shipped partially charged. Before you start using your
device, it is recommended that you install and charge the battery. Some
batteries perform best after several full charge/discharge cycles. You can
charge the battery in two ways:
• Charging the device’s battery by connecting the power adapter.
• Connecting your device to a PC via the provided USB Sync cable.
Note Only the AC adapter and USB cable provided with your device should be
used to charge the device.
Charging is indicated by a solid amber light on the left LED indicator.
As the battery is being charged while the device’s power is on, a charging
icon ( ) will be shown at the bottom right side of the Today screen.
After the battery has been fully charged, the left LED becomes green and a
full battery icon ( ) appears at the bottom right side of the Today screen.
Warning! • Do not remove the battery from the device while you are charging it
using the AC or car adapter.
• As a safety precaution, the battery stops charging when it overheats.