AMX TPI-PRO-2 - Manual (Page 38)

Configuring Communication
32 TPI-PRO Total Presentation Interface - Pro Edition
7. Use the Baud Rate Up/Down arrows to cycle through the available baud rates for TPI-PRO serial
communication to the connected PC. The default is 38400.
8. Obtain the System Number and Master IP Address from NetLinx Studio. This information must be
specific for the system used with the configured TPI-PRO.
9. Press the System Settings button (located on the Protected Setup page) to open the System Settings
page (FIG. 24) and begin configuring the communication settings on the TPI-PRO to match those of
the target Master.
10. Press the on-screen Reboot button to restart the TPI-PRO and incorporate any changes.
FIG. 23 Protected Setup page with Keypad
Before continuing, open NetLinx Studio. This program assists in developing a System
Number, Master IP/URL, and Master Port number. Refer to your NetLinx Master’s
instruction manual for more information.
FIG. 24 System Settings page