HP Принтер серии HP Designjet 9000s - Manual (Page 18)

18 User´s Guide
3.4 Enter tthe ccode oof tthe nnew rreplacement ffilter
In order to reset the service interval one code must be entered with the HP Designjet 8000s Air
Purifier System. Two codes are necessary with the HP Designjet 9000s/10000s Air Purifier
System. The code input for the 8000s and 9000s/10000s is explained in the following chap-
ters.
3.4.1 H
HP D Designjet 88000s A Air PPurifier SSystem
After replacing the filter element the service interval must be reset using the code. The following
steps must be carried out in the following order:
Switch the APS on at the membrane keyboard using the button ON/OFF. When it
switches on you will hear the fan and it will begin to extract the gases.
If "service filter" is shown in the display you must press the button "+" or "– " to
suppress this fault report.
By pressing the button ENTER the programme name is displayed.
By pressing the button ENTER again "
code 1: 00000
" is displayed.
Now you can enter the code using these buttons. The code is on the flyer which is
enclosed with the new filter element.
By pressing the button ENTER the actual code is saved.
If this code has been entered correctly the value for the filter contamination (middle indication
in the display) is reset to "0%" and the blinking green (run) and red ( error ) LEDs will be reset.
Note
The code is on the flyer that is enclosed with the new filter element.