HP Принтер серии HP Designjet 9000s - Manual (Page 21)

21 HP Air Purifier System
5 Troubleshooting
Fault Cause Correction
No suction
output
(fumes/gases
are not being
extracted).
Suction hose not connected
to the APS.
Connect suction hose to the APS.
Suction hose not connected
to the machine
Connect suction hose to the printer.
Damage to the suction
hose.
Replace suction hose.
Suction hose is connected
to the wrong machine.
Connect suction hose to the correct
machine.
Suction hose is connected
to the wrong point of entry
(opening) of the machine.
Connect suction hose to the right point of
entry (opening) of the machine.
Suction channel blocked. Check suction channel, if necessary cor-
rect error found.
Clean gas channel blo-
cked.
Check clean gas channel, if necessary
correct error found.
Suction output
too low
(fumes/gases
are hardly
being extracted).
Filter elements full. Replace filter package, dispose of old fil-
ter properly!
Damage to the suction
hose.
Replace suction hose.
Suction hose not correctly
connected to the APS.
Check fitting of the suction hose to the
APS, if applicable reinsert into suction
opening.
Suction hose not correctly
connected to the machine.
Check fitting of the suction hose to the
machine if necessary reconnect.
Air outlet blocked. Check air outlet status,and clean blocke
holes.
Suction hose is connected
to the wrong point of entry
(opening) on the machine.
Connect suction hose to the right point of
entry (opening) on the machine.
Fault on the APS. Contact your HP Service representative.
APS is not
running.
Plug connection power sup-
ply not or wrongly plugged
in.
Check/correctly plug in plug connection
power supply.
No power on the socket. Check power supply, if necessary correct
error.
Fault on the APS. Contact your HP Service representative.