Aiwa XD-DV370 - Manual (Page 10)

10
Input jack of equipment to be
connected to the DVD player
Digital input jack
Analog audio input jacks (L/R)
Digital input jack
Analog audio input jacks (L/R)
Digital input jack
CONNECTIONS
Before making connections
• Connect the AC cords of the unit and external
equipment at the end, after finishing the other
connections.
• Insert the plugs completely into the jacks. Loose
connections may produce a humming sound or other
noise interference.
• When using an optical connection, remove the dust cap
from the DIGITAL OUT (OPTICAL) jack on the rear of
this unit. Keep the cap in store. When not using optical
connections, the dust cap should be in place.
• Refer to the instructions for the connected equipment.
At first, decide the outline of the connection among this unit, your TV set and the amplifier, etc. It is necessary to set the
setup menu of this unit according to the connection.
Before connection, identify the type of your audio equipment or of the TV set referring to the following chart. Then decide
the connection and the setup menu according to the types.
CAUTION
Do not select “DOLBY DIGITAL/PCM or Stream/PCM” in
the “Digital Audio Output” when connecting to an AV
amplifier not equipped with a Dolby Digital decoder or DTS
decoder (with an optical or coaxial connecting cord).
Merely attempting to play a DVD may cause a high level of
noise which could be harmful to your ears and damage
the speakers. In such a case, be sure to select “PCM” in
the “Digital Audio Output”.
Referring
Letter
See A .
See B .
See C .
See D .
See F .
See E .
Audio system to be connected
None (only the television is connected)
A stereo system or an amplifier
An AV amplifier equipped with Dolby Digital
decoder or a Dolby Digital decoder
An AV amplifier equipped with DTS decoder
or a DTS decoder
NOTES
• When the picture noise appears while copy-protected
DVDs are played, connect the unit directly to a TV set.
Do not connect through a VCR, TV/VCR or AV selector.
• For the speakers and their connection, refer to the
instructions for the AV amplifier.
TV SYSTEM SELECT switch
This switch enables you to make use of a TV set which is
NTSC or Multi colour system. The default setting is “PAL”.
Before turning on the unit;
• Set to “PAL”, when connecting to the TV set of PAL colour
system.
• Set to “AUTO”, when connecting to the TV set of Multi
colour system.
• Set to “NTSC”, when connecting to the TV set of NTSC
colour system.
NOTE
The unit cannot playback DVDs and video CDs that are
recorded in the PAL colour system, if “NTSC” is set.
AUDIO OUT
VIDEO OUT
S-VIDEO
DIGITAL OUT
OUT
COAXIAL L
R NTSC PAL AUTO
OPTICAL
DIGITAL OUT
NTSC
PAL AUTO