Aiwa XD-DV370 - Manual (Page 12)

12
CONNECTIONS (CONTINUED)
AUDIO
OUT
VIDEO
OUT
S-VIDEO
DIGITAL OUT
OUT
COAXIAL L
R
NTSC
PAL AUTO
OPTICAL
DIGITAL
OUT
B Connecting to a TV set and an amplifier with a Digital In jack
Use either the commercially available optical cord or 75 ohm coaxial cord when connecting this unit to an AV amplifier with
a Digital In jack. The supplied video cord is also available instead of the coaxial cord.
Set the setup menu correctly after connecting!
According to the audio equipment and TV set to which the
unit is connected, set the “Digital Audio Output” and “TV
Aspect” of the setup menu correctly referring to the
following below.
See “CHANGING SETUP VALUE” on page 39 in detail.
Digital Audio Output
PCM
to a digital input jack
TV set
Front
speaker (L) Front speaker
(R)
Rear of the unit
Amplifier with a Digital In jack
Optical cord (not supplied)
When your TV set is equipped with an S-video input terminal, see page 17.
to 21 pin scart
connector
to DIGITAL OUT
OPTICAL jack
NOTE
When the picture noise appears while copy-protected DVDs
are played, connect the unit directly to a TV set. Do not
connect through a VCR, TV/VCR or AV selector.
TV Aspect
When your TV set is a conventional-screen size TV:
4:3 Letter box
When your TV set is a wide-screen size TV:
16:9 Wide
to DIGITAL OUT
COAXIAL jack
or Coaxial cord
(not supplied)
21 pin scart cable (not supplied)
to 21 pin scart
connector
to an AC power socket
(AC 230 V, 50 Hz)