Aiwa XD-DV370 - Manual (Page 14)

14
CONNECTIONS (CONTINUED)
AUDIO
OUT
VIDEO
OUT
S-VIDEO
DIGITAL OUT
OUT
COAXIAL L
R NTSC
PAL AUTO
OPTICAL
DIGITAL
OUT
D Connecting to an AV amplifier equipped with a Dolby Digital (AC-3) decoder
Use either the commercially available optical cord or 75 ohm coaxial cord when connecting this unit to an AV amplifier with
a Digital In jack. The supplied video cord is also available instead of the coaxial cord.
TV set
Rear of the unit
Front speaker
(R)
Front
speaker (L)
Optical cord (not supplied)
Amplifier equipped with a Dolby
Digital decorder
to DIGITAL OUT
OPTICAL jack
to a digital input jack
When your TV set is equipped with an S-video input terminal, see page 17.
Centre speaker Subwoofer Surround speaker (R) Surround speaker (L)
Set the setup menu correctly after connecting!
According to the audio equipment and TV set to which the
unit is connected, set the “Digital Audio Output” and “TV
Aspect” of the setup menu correctly referring to the following
below.
See “CHANGING SETUP VALUE” on page 39 in detail.
Digital Audio Output
DOLBY DIGITAL/PCM
TV Aspect
When your TV set is a conventional-screen size TV:
4:3 Letter box
When your TV set is a wide-screen size TV:
16:9 Wide
NOTE
When the picture noise appears while copy-protected DVDs
are played, connect the unit directly to a TV set. Do not
connect through a VCR, TV/VCR or AV selector.
CAUTION
If the AV amplifier is not equipped with a Dolby Digital
decoder, do not select “DOLBY DIGITAL/PCM” in the
“Digital Audio Output” when connecting the AV amplifier
with an optical or coaxial connecting cord.
Merely attempting to play a DVD may cause a high level of
noise which could be harmful to your ears and damage the
speakers. In such a case, be sure to select “PCM” in the
“Digital Audio Output”.
to DIGITAL OUT
COAXIAL jack
or Coaxial cord
(not supplied)
21 pin scart cable (not supplied)
to 21 pin scart connector
to 21 pin scart
connector
to an AC power socket (AC
230 V, 50 Hz)