Ampro Corporation 486E - Manual (Page 69)

Product Reference
2–53
Using EPROMs
)If you install an EPROM in socket S0, make sure the jumper on W2 is set properly. Some EPROMs
draw current through their chip select lines (or other pins) when powered down. Table 2–40 lists
the Flash EPROM jumpering for S0.
Table 2–40. Flash EPROM Jumpering for S0
Flash EPROM
Typical Devices
Pins Jumper Diagram
128K 5V Flash EPROM - 29F010
256K 5V Flash EPROM - 29F020
512K 5V Flash EPROM - 29F040 32
1 3
7 9
FLASH EPROM Programming
To program a Flash device in byte-wide socket S0, use the FlashWRI.EXE utility supplied on the
Common Utilities diskette. The Common Utilities manual describes its operation. Only devices
with 5V programming power are supported.
Custom Flash-programming routines can be developed using extended BIOS calls in the ROM
BIOS. Contact Ampro Technical Support for information about the extended BIOS call provided for
Flash programming power.