HP xw4400 Workstation - Manual (Page 27)

LSI 3041E and Integrated LSI 1064/1068 Setup
The LSI 3041E is a 4-port SATA/SAS RAID controller providing SAS support for the HP xw4000 and
xw6000 Workstation series as well as the Z400 and Z600.
NOTE: While the controller provides functionality for SATA RAID, SATA RAID is not supported on HP
Linux Workstations.
The HP xw8000, xw9000, and Z800 Workstation series use an onboard LSI 1064, 1068 or 1068e
SAS controller, which uses the same BIOS configuration utility as the LSI 3041E plug-in card.
Use the following steps as a guide to set up the LSI 3041E or the onboard LSI controllers for SAS RAID.
Details vary based on the specific configuration, such as RAID level and number of disks used.
1. Boot the workstation.
2. When prompted, press any key to view option ROM messages. A message indicating the
presence of the LSI onboard controller or plug-in card and the LSI Logic MPT SAS BIOS appears.
Figure 6-1 LSI Logic MPT SAS BIOS
LSI 3041E and Integrated LSI 1064/1068 Setup 23