HP Storage Mirroring Software - Manual (Page 34)

Migration Page 33 of 135
If your source was disconnected from the network during the cutover process, the
original job that was mirroring the data will still be active on that machine. Do not
bring that machine back on the network. If you do, the original job will attempt to
begin mirroring data again which could result in data loss. While the machine is
still disconnected from the network, stop the Storage Mirroring service, delete the
file connect.sts located in the Storage Mirroring Data Migration installation
directory, and then restart the Storage Mirroring. This will delete the original job.
After the original job is deleted, you can bring the machine on the network if
desired.