HP Storage Mirroring Software - Manual (Page 80)

Job monitoring Page 79 of 135
4111 Target can not write %1 due to a sharing violation. Operation will be retried
(%2 times or forever)
Warning—A sharing violation error is prohibiting Storage Mirroring from
writing on the target. The operation will be retried according to the
TGExecutionRetryLimit setting.
4112 Target can not write %1 due to access denied. Operation will be retried (%2
times or forever)
Warning—An access denied error is prohibiting Storage Mirroring from
writing on the target. The operation will be retried according to the
TGExecutionRetryLimit setting.
4113 Target can not write %1 due to an unknown reason. Operation will be retried
(%2 times or forever). Please check the log files for further information on the error.
Warning—An unknown error is prohibiting Storage Mirroring from writing
on the target. The operation will be retried according to the
TGExecutionRetryLimit setting.
4120 Target write to %1 was completed successfully after %2 retries.
Information—No action required.
4150 Target write %1 failed after %2 retries and will be discarded. See the event log
or log files for error conditions. After correcting the problem, you should re-mirror
or run a verify to resynchronize the changes.
Error—The operation has been retried according to the
TGExecutionRetryLimit setting but was not able to be written to the target
and the operation was discarded. Correct the problem and remirror the
files.
4155 The service was unable to complete a file system operation in the allotted
time. See the log files for error conditions. After correcting the problem, remirror or
perform a verification with remirror to synchronize the changes.
Warning—Correct the file system error and then remirror or perform a
verification with remirror to synchronize the changes.
4200 In band task %1 submitted from %2 by %3 at %4
Information—No action required.
4201 In band task %1 discarded (submitted from %2 by %3 at %4)
Warning—A task may be discarded in the following scenarios: all
connections to a target are manually disconnected, replication is stopped
for all connections to a target, or an auto-disconnect occurs. If one of these