HP NonStop G-Series - Manual (Page 20)

Configuration of remote access (dial-in) and remote notification (dial-out) information ●
Configuration of dial-out point status for your system console ●
Specification of the interval at which your OSM server generates periodic incident reports ●
Authorization (automatically or manually) of incident reports to be dialed out to your service
provider ●
Note: You can receive and dial out incident reports only from systems for which your system
console is a primary or backup dial-out point.
OSM Guided Procedures
Guided procedures are launched by OSM actions:
OSM Guided Procedure OSM Action For Object
Replace PMF, IOMF, SNDA,
SEB, MSEB
Replace Each CRU
Replace Switch II Component Replace
HP NonStop Cluster Switch (model
6770) and subcomponents (UPS and
AC transfer switch)
Replace 6780 Switch Replace
HP NonStop ServerNet Switch (model
6780) and subcomponents (logic board
and PIC)
Replace ServerNet Switch Board
or IOAM Enclosure
For the IOAM Enclosure,
the action is Replace
IOAM Enclosure or
ServerNet Switch Board.
For the ServerNet Switch
Board, the action is
Replace.
IOAM Enclosure and ServerNet
Switch Board
Replace Disk Drive Enclosure
(or component)*
Replace
Disk Drive Enclosure and
subcomponents (Fibre Channel disk
drive, FC-AL I/O module, EMU,
power supply, and blower)
Add Node to ServerNet Cluster
(formerly Configure ServerNet
Node)
Add Node to ServerNet
Cluster
System
* Should be performed only by a trained service provider.
Note: You must be logged on as a super-group user to perform OSM guided procedures.
You can minimize the OSM Service Connection Management window, but must not close
it. If the session you launched the guided procedure from is closed or becomes
disconnected, the guided procedure will close and fail to complete.
Some former TSM guided procedures have been replaced by OSM actions:
TSM Guided Procedure OSM Action For Object