AMX MAX-CSE - Manual (Page 56)

Configuring Communication
50 MAX-CSE/MAX-CSD10 Operation/Reference Guide
Configuring the MAX Communication Parameters
Although the unit is initially configured to obtain the first available DHCP Address, it is recommended
that after the initial connection, the unit be setup to use a Static IP Address. Using a Static IP Address for
both the source and destination devices can be beneficial for both diagnostic and direct access purposes.
Obtaining the unit’s initial DHCP Address
1. Connect an Ethernet cable to the unit’s rear Ethernet connector.
2. Connect the 2-pin 3.5mm mini-Phoenix PWR connector to the rear power connector and then apply
power.
3. After the unit has successfully obtained an IP Address from the DHCP Server, it then displays this
obtained DHCP Address across the front LCD (FIG. 32).
4. Write down the newly obtained DHCP Address displayed on the front panel LCD.
Communicating with the unit via the browser-based UI
To facilitate communication with the MAX-CSE and MAX-CSD10, it is necessary for the unit to obtain
a DHCP Address. Once that address is known, you can then use your web browser to access the browser-
based User Interface (UI) pages and then configure the project, video, and IP connection parameters.
1. Launch your web browser.
2. Enter the IP Address of the target unit (ex: http://192.199.99.99) into the web browser’s Address
field.
3. Press the Enter key on your keyboard to initiate the communication process and launch the initial
on-screen Enter Network Password security dialog. (FIG. 33).
4. Enter the words administrator and password into the corresponding User Name/Password fields
(case-sensitive). This is the factory default security login information. This login profile can later be
changed.
5. Place a checkmark in the Use the Save this password in your password list selection box to save
both the username and password to the MAX unit and use them as your defaults during the next new
login to the target unit.
Unchecking this "save login profile" option causes a user to have to re-enter both the username
and password upon every consecutive login. Leaving this box unchecked helps add to the
security feature of the unit by requiring the user to have the proper information.
MAX Products are not designed or intended to, and may not be used to, violate
anyone’s copyright or other intellectual property rights. Each user of the MAX
Products may only use the products in connection with materials legally owned or
licensed by such user and only to the extent such ownership or license rights permit
such use.
The MAX-CSE uses the active Ethernet connection to communicate with the DHCP
Server and obtain a valid DHCP Address.
FIG. 32 Example of the current IP Address