Connect the water hose, Plug in the system, Setup – HP Designjet 3D Printer series User Manual
Page 11
Advertising
Connecting the system 7
Connect the water hose
Screw on the end of the water supply hose to the back panel of the system. Securely tighten the
fitting clockwise. Turn on the water and make sure there are no leaks.
Figure 6
Water hose connections
Plug in the system
Securely plug one end of the supplied power cord into the receptacle at the back of the system
and the other end of the power cord into a grounded receptacle. Only use the power cord
provided.
Setup
Advertising