HP Storage EVA Capacity Upgrades - Manual (Page 10)

10 Switch Installation
• If the SFP has a small plastic slider on the top or bottom, remove the cable from the SFP and then
push in the slider and hold while pulling out the SFP.
• If the SFP has a bale (small metal clasp), remove the cable from the SFP and then unlatch, pivot,
and pull the bale.
Attaching a Device to the Switch
To attach a device:
1. Make sure that the device is FC-AL compatible.
2. Attach a cable to the device.
3. Attach the other end of the cable to an SFP.
4. Make sure that the device and switch are operational and set to the same speed.