HP Identity Driven Manager Software Licenses - Manual (Page 71)

3-7
Using Identity Driven Manager
Configuring Locations
7. Use the Port Selection section to define the ports on the device that will be
associated with the location.
• Click to select Any port on the switch, or
• Click Select ports, then use the lists to select the Begin and End ports on
the device that will be associated with the new location.
If you manually entered the device address, the Begin port and End port
menus are disabled, and you must manually enter the ports.
8. Click OK to save the New Device settings to the Location, and close the window.
N o t e s : If a switch in the device list is not configured to authenticate with the RADIUS
server, the settings in IDM will have no affect.
You can type in an IP address for non-PCM devices and if the device uses industry
standard RADIUS protocols, the settings should work; however, HP does not
provide support for IDM configurations with non-PCM devices.
9. The Device address and ports information is displayed in the New Location
window.
10. Repeat steps 4 through 7 to add additional devices to the Location, or click OK
to save the new Location and close the window.
To add a wireless device to a Location:
1. On the Create a new Location window, click the Wireless devices tab.