ACR Electronics Nauticast Y1-03-0212 - Manual (Page 93)

Quick Replacement Guide
Inland AIS
1. Prepare the following tools:
Screwdrivers, spanners,
User Password: [your personal password]
(Should be written to you user manual - Appendix 7.3.
The factory default password is on the display foil)
2. Read out your Transponder configuration:
This form guides you to save the most important
settings (bold marked) prior to an AIS replacement.
Voyage related settings may be stored here as well, but
we assume you know how to key them in.
Steps to do this:
Press Menu
Press 2
2.AIS Status
Press 2 2.Own Ship Data
Write down your current configuration settings:
IMO No. : MMSI:
ShipName : ATIS:
ShipType : Cargo:
Length : Beam :
Cargo :
Draught :
(Press Enter to reach 2.screen view for)
ENI:
Blue Sign:
Convoy:
Load: Hazard:
Persons on Board:
Crew: Support:
Int’l: Passengers:
Reference Points:
Press Menu
Press 4
4.Ship Settings
Type in [UserPassword] Press Enter
Write down the current configuration settings here:
RefPtExt: A
B C D
RefPtInt: A B C D
Blue Sign:
Press
Menu
Press 5 5.Transponder Configuration
Type in [UserPassword] Press Enter
Press 7. 7.Inland AIS Configuration
Speed: <LOW*> or <High*>
Course : <LOW*> or <High*>
Heading: <LOW*> or <High*>
Blue Sign: [not avaliable] or [Used]
*(most time LOW)
Sensor Settings:
When you have connected a external GPS or Compass
to your AIS:
Press
Menu
Press 5 5.Transponder Configuration
Type in [UserPassword] Press Enter
Press 5 5.Sensor Settings
Type in [ServicePassword] Press Enter
Write down the current configuration
settings here:
BaudRate Sensor1:
BaudRate Sensor2:
BaudRate Sensor3:
Press
M8 Back
3. Detach the device
3.1. Bracket Mounting
3.2. Frame Mounting
4. Disconnect cables
4.1. AIS-Cable to unscrew
4.2. VHF/GPS Cable to unscrew
5. Unpack the new Transponder
New factory default password is on its display
protection foil
6. Connect cables
6.1. AIS-Cable to screw on
6.2. VHF/GPS Cable to screw on
7. Mount the replacement unit
7.1. Bracket Mounting
7.2. Frame Mounting
8. Type in the configuration settings from
above:
Following steps to type in the Configuration
MMSI/IMO
– Number:
The AIS will prompt ‘ENTER MMSI NUMBER’
Press M5 OK
Type in MMSI and IMO number
Press M5 Save (AIS will Restart)