HP StorageWorks 2.32 Edge Switch - Manual (Page 187)

Edge Switch Element Manager user guide 187
Cannot perform
operation. The list of
attached nodes is
unavailable.
Attached nodes are unavailable
and you attempt to modify a zone
or create a new zone.
Verify that an attached node is
available and retry the operation.
Cannot retrieve
current SNMP
configuration.
The current SNMP configuration
could not be retrieved.
Try again. If the problem persists,
contact the next level of support.
Cannot save current
SNMP configuration.
The current SNMP configuration
could not be saved.
Try again. If the problem persists,
contact the next level of support.
Cannot set write
authorization without
defining a community
name.
An SNMP community name has
not been configured.
Enter a valid community name in the
Configure SNMP dialog box.
Cannot show zoning
library. No fabric
exists.
You cannot show the zoning
library if no fabric exists. You
must have identified a switch or
director to the HAFM application
for a fabric to exist.
Identify an existing switch or director to
the HAFM application using the New
Product dialog box.
Click OK to remove all
contents from log.
This action deletes all contents
from the selected log.
Click OK to delete the log contents or
Cancel to cancel the operation.
Connection to
management server
lost.
The connection to the remote
HAFM appliance has been lost.
Log in to the HAFM appliance again
through the HAFM Log In dialog box.
Connection to
management server
lost. Click OK to exit
application.
The HAFM application at a
remote workstation lost the
network connection to the HAFM
appliance.
Re-start the HAFM application to
connect to the HAFM appliance.
Could not export log
to file.
A log file input/output (I/O) error
occurred and the file could not be
saved to the specified destination.
The disk may be full or write
protected.
If the disk is full, use another disk. If the
disk is write protected, change the
write-protect properties or use another
disk.
Default zoning is not
supported in Open
Fabric Mode.
A default zone cannot be enabled
when the product is enabled for
Open Fabric mode. Open Fabric
mode does not support zone
members defined by port
numbers.
Change the Interop Mode from Open
Fabric to Homogeneous using the
Configure Fabric Parameters dialog
box. You can also redefine zone
members by the device WWN.
Table 9 HAFM messages (continued)
Message Description Action