HP StorageWorks XP Remote Web Console Software - Manual (Page 39)

3. Click Apply in the LUN Manager window.
A message appears and asks if you want to apply the setting to the storage system.
4. Click the OK button to close the message.
The settings are applied to the storage system and the specified host is registered in the host
group.
Figure 25 Add New WWN Dialog Box (When Registering a Host that Has Previously been Connected
to the Storage System)
Figure 26 Add New WWN Dialog Box (When Registering a Host that Has Never been Connected
to the Storage System)
NOTE: If the WWN list (located near the lower-left corner of the window) includes a host that
you want to register, you can register the host by dragging the host from the WWN list to the
desired host group in the tree.
Defining LU Paths by Associating Host Groups to Logical Volumes
Use LUN Manager to define LU paths by associating host groups with logical volumes. For example,
if you associate a host group consisting of three hosts with logical volumes, LU paths are defined
between the three hosts and the logical volumes.
NOTE: When you use a logical volume larger than 2 TB, whether the host can access a logical
volume larger than 2 TB depends on the operating system of the host.
The following operating systems support a logical volume that is larger than 2 TB.
•
AIX 5.2 TL08 or later
•
AIX 5.3 TL04 or later
Defining Fibre Channel LU Paths 39