HP Color LaserJet Enterprise CP4525 Printer series - Manual (Page 111)

Configure trays
The product automatically prompts you to configure a tray for type and size in the following situations:
● When you load paper into the tray
● When you specify a particular tray or media type for a print job through the printer driver or a
software program and the tray is not configured to match the print-job’s settings
NOTE: The prompt does not appear if you are printing from Tray 1, and it is configured for the ANY
SIZE and ANY TYPE settings. In this situation, if the print job does not specify a tray, the product prints
from Tray 1, even if the paper size and type settings in the print job do not match the paper loaded in
Tray 1.
Configure a tray when loading paper
1. Load paper in the tray. Close the tray if you are using Tray 2, 3, 4, or 5.
2. The tray configuration message appears.
3. Press the back arrow to accept the size and type, or press the OK button to choose a different
paper size or paper type.
4. To modify the tray size configuration, press the down arrow to highlight the correct size, and then
press the
OK button.
5. To modify the tray type configuration, press the down arrow to highlight the correct type, and
then press the
OK button.
Configure a tray to match print job settings
1. In the software program, specify the source tray, the paper size, and the paper type.
2. Send the job to the product.
If the tray needs to be configured, the LOAD TRAY <X> [TYPE] [SIZE] message appears.
3. Load the tray with the specified type and size of paper, and then close the tray.
4. When the TRAY <X> SIZE = <Size> message appears, press the OK button to confirm the size.
5. When the TRAY<X> TYPE=<TYPE> message appears, press the OK button to confirm the type
and continue with the job.
Configure a tray by using the Paper Handling menu
You can also configure the trays for type and size without a prompt from the product.
1. Press the Home button .
2. Press the down arrow to highlight the PAPER HANDLING menu, and then press the OK button.
3. Press the down arrow to highlight the size or type setting for the desired tray, and then press the
OK button.
4. Press the up arrow or the down arrow to highlight the size or type. If you select a custom size,
select the unit of measure, and then set the X dimension and the Y dimension.
ENWW Configure trays 97