HP ProLiant SL2500 Scalable System - Manual (Page 59)

General commands 59
Showing configurations
To show the configuration, enter SHOW CONFIG. A list of commands representing the configuration of HP
APM appears.
Using the help
To access the help, enter HELP. The following listing appears:
APM-D4C9EFCB00B4> help
ADD Add entity
CLEAR Empty log entries
CLOSE Close rack's doors
CONFIG Configure HP APM
CONNECT Connect board peripherals
CONTROLLER Rack controller controls
DISABLE Turn off board features
ENABLE Turn on board features
EXIT Exit CLI
HELP Show help messages
LOGOUT Exit CLI
OPEN Open rack's doors
QUIT Exit CLI
PING Ping a remote host
REBOOT Reboot firmware
REMOVE Remove entity
RESET Reset HP APM
SAVE Save HP APM config or zones
SET Set board configuration
SHOW Display information
TEST Test commands
UPGRADE Pull in new firmware
Each listing has its own listings. For example, when HELP CLEAR is entered, the following appears:
HP APM> help clear
CLEAR Empty log entries
FAULTS Empty the fault log
LOG Empty system log
SCREEN Clear the screen
This listing shows the items that you can clear:
• To empty the fault log, enter CLEAR FAULTS.
• To empty the system log, enter CLEAR LOG.
• To clear the screen, enter CLEAR SCREEN.
Setting the name
To set the name that appears in the log and syslog entries, enter SET NAME "<name>". For example:
SET NAME "alphabravo"
System names can be up to 80 characters, and can include uppercase letters, lowercase letters, underscores
(_), dashes (-), and numerical values between 0-9. Dashes (-) are not supported as the first character. To save