HP ProLiant SL2500 Scalable System - Manual (Page 56)

General commands 56
Account MyLogin123 enabled
myslapm>
The account name must be between2-32 characters. If you attempt to use more than 32 characters, you will
receive an error message:
myslapm> add account
"adkfjklsdjflsdjflsjflksdjfkljsdkljfklsdjfkljsdklfjsdljfklsdj"
Account name has invalid character or is reserved
Account name must be 2-32 characters
Valid characters are A-Z,a-z,0-9,_,and -.
After you enter this command with a valid new username, a prompt asking for a password appears. Enter the
password. The new account is available for system login.
If you do not specify a password, and the username does not already exist, then you are prompted for a
password.
All user accounts have the same permissions.
NOTE: Login accounts and passwords are stored separate from the board configuration. A
SHOW CONFIG command will not reveal any ADD ACCOUNT commands.
Removing an account
To remove an account, enter REMOVE ACCOUNT “<username>”
where:
"<username>" is the account username.
This command removes the specified account from the system. If the user does not exist, then an error
message appears.
The Administrator account cannot be deleted.
Showing accounts
To show the existing defined accounts, including the reserved Administrator account, enter SHOW
ACCOUNTS.
For example:
myslapm> show accounts
Administrator
root
myslapm>
Working with zones
HP APM enables the addition, removal, and showing of chassis to a zone, and the saving of zones.
Adding zones
To add one or more chassis to a zone, enter