51 screw locations on the base-module power supply, 52 removing the base-module power supply bracket – HP EML E-series Tape Libraries User Manual
Page 90
10466
Figure 51 Screw locations on the base-module power supply
WARNING!
The power supply might be hot.
5.
Pull the handle on the power supply to remove it from the library.
6.
The bracket is not part of the replacement kit. You must move the bracket from the original power
supply to the new power supply. Remove the two 6-32 x 1/4-inch Torx screws that attach the bracket
to the power supply with a T-15 Torx screwdriver.
10467
Figure 52 Removing the base-module power supply bracket
Replacing a power supply in the base module or tape drive expansion module
1.
Attach the bracket to the new power supply with two 6-32 x 1/4-inch Torx screws. Use a T-15
Torx screwdriver.
2.
Slide the power supply into the library.
3.
Attach the power supply to the library with two 6-32 x 3/8-inch Torx screws.
90
Removing and replacing parts