HP StorageWorks 2.140 Director Switch - Manual (Page 159)

HA-Fabric Manager user guide 157
• Finding zones in a zone set , page 159
• Displaying zone members , page 159
• Saving the active zone set to a zoning library , page 160
• Comparing zone sets , page 160
Renaming a zone or zone set
To rename a zone or zone set:
1. Display the zone library. See ” Displaying the zone library ” on page 149.
The Zoning dialog box is displayed ( Figure 91 on page 149).
2. Right-click the zone or zone set that you want to rename and select Rename.
3. Enter the new name. See ” Zoning naming conventions ” on page 148.
4. Press Enter to save the new name.
Replacing zone members
You can replace zone members in one of two ways:
• Select the replacement zone member from the Potential Zone Member list.
• Specify the replacement member’s domain/port or WWN.
Using the Potential Zone Members list
To replace a zone member:
1. Display the zone library. See ” Displaying the zone library ” on page 149.
The Zoning dialog box is displayed ( Figure 91 on page 149).
2. Select the member you want to replace from the Potential Zone Members list.
3. Click Find to find all instances of the member in the configured zones.
4. Click to the right of the Potential Zone Members list to remove the member from the zones.
5. Select the replacement member from the Potential Zone Members list.
6. Click to the right of the Potential Zone Members list to add the member to the zones.
7. Click OK.
Using the domain/port or WWN
To replace a zone member:
1. Display the zone library. See ” Displaying the zone library ” on page 149.
The Zoning dialog box is displayed ( Figure 91 on page 149).
2. Right-click the member you want to replace and select Replace, or right-click in the Zones area
and select Replace All.