HP StorageWorks 2.140 Director Switch - Manual (Page 223)

HA-Fabric Manager user guide 227
Remote session support
has been disabled.
The connection between
the specified remote
workstation and the
HAFM appliance was
disallowed.
Consult with the customer’s network
administrator to determine if the
workstation entry should be
modified at the Remote Access
dialog box.
Resource is unavailable. The specified operation
cannot be performed
because the product is
unavailable.
Verify the HAFM
appliance-to-product link is up. If
the link is up, the HAFM appliance
can be busy. Try the operation
again later.
Route data corrupted. The information for this
route is corrupt.
Try the operation again. If the
problem persists, contact the next
level of support.
Route request timeout. The Show Route request
timed out.
Try the operation again. If the
problem persists, contact the next
level of support.
Routing is not supported
by the switch.
This switch or director
does not support the
Show Routes feature.
Choose a different switch or
director to show the route.
SANtegrity Feature not
installed. Please contact
your sales representative.
You selected Fabric
Binding or Enterprise
Fabric Mode from the
Fabrics menu. These
selections are not
enabled because the
optional SANtegrity
binding feature is not
installed.
Install the SANtegrity Binding
feature to use Fabric Binding or
enable Enterprise Fabric Mode.
Select alias to add to
zone.
An alias was not selected
before clicking Add.
Choose an alias before clicking
Add.
Selection is not a World
Wide Name.
The selection made is not
a WWN.
Choose a valid WWN before
performing this operation.
Server shutting down. The HAFM application is
closing and terminating
communication with the
attached product.
Reboot the HAFM appliance. If the
problem persists, contact the next
level of support.
SNMP trap address not
defined.
If an SNMP community
name is defined, a
corresponding SNMP
trap recipient address
must also be defined.
Enter a corresponding SNMP trap
recipient address.
Table 30 HAFM Messages (continued)
Message Description Action