HP StorageWorks 2.140 Director Switch - Manual (Page 222)

Informational and error messages 226
No zone member
selected.
A zoning operation was
attempted without a zone
member selected.
Choose a zone member and try the
operation again.
No zone selected. A zoning operation was
attempted without a zone
selected.
Choose a zone and try the
operation again.
No zone selected or zone
no longer exists.
A zoning operation was
attempted without a zone
selected, or the zone
selected no longer exists
in the fabric.
Choose a zone and try the
operation again.
No zone set active. A zone set cannot be
deactivated if there are
no active zones.
Informational message only—no
action is required.
No zone set selected. A zoning operation was
attempted without a zone
set selected.
Choose a zone set and try the
operation again.
No zone set selected or
zone set no longer exists.
A zoning operation was
attempted without a zone
set selected, or the zone
set you selected no longer
exists in the fabric.
Choose a zone set and try the
operation again.
Only attached nodes can
be displayed in this
mode.
You cannot display
unused ports when
adding ports by WWN.
Change the add criteria to Add by
Port.
Password and
confirmation don’t match.
Entries in the password
box and confirmation
password box do not
match. The entries are
case sensitive and must
be the same.
Enter the password and
confirmation password again.
Remote sessions are not
allowed from this network
address.
Only IP addresses of
remote workstations
specified at the Remote
Access dialog box are
allowed to connect to the
HAFM appliance.
Consult with the customer’s network
administrator to determine if the IP
address is to be configured for
remote sessions.
Table 30 HAFM Messages (continued)
Message Description Action