HP StorageWorks 2.140 Director Switch - Manual (Page 247)

HA-Fabric Manager user guide 251
Port numbers must be in
the range of 0 to xxx.
When configuring
Preferred Paths, source
ports and exit ports must
be in the range of ports
for the switch being
configured.
In the Configure Preferred Paths
dialog box, change the numbers in
the Source Port and Exit Port boxes
to fall within the port count of the
switch on which you are
configuring paths.
Preferred Paths can not be
enabled until the Domain
ID is set to Insistent.
Disable Preferred Paths,
then configure Switch
Parameters.
If the switch’s domain ID
has not been set to
Insistent, the user is not
allowed to activate the
Preferred Path
configuration with the
Enable Preferred Paths
check box selected.
Close the Configure Preferred Paths
dialog box and select Configure >
Operating Parameters > Switch
Parameters. In the Configure
Switch Parameters dialog box, click
the Insistent check box.
R_A_TOV must be greater
than E_D_TOV.
R_A_TOV must be greater
than E_D_TOV.
Change one of the values so that
R_A_TOV is greater than E_D_TOV
Resource is unavailable. The specified operation
cannot be performed
because the product is
unavailable.
Verify that the Ethernet connection
between the HAFM appliance and
the director is up or available.
Resource is unavailable. The specified operation
cannot be performed
because the product is
unavailable.
Verify that the HAFM
appliance-to-product link is up. If
the link is up, the HAFM appliance
can be busy. Try the operation
again later.
SANtegrity Feature not
installed. Please contact
your sales representative.
You selected Switch
Binding from the
Configure menu, but the
optional SANtegrity
Binding feature is not
installed.
Install the SANtegrity Binding key
through the Configure Feature Key
dialog box before using Switch
Binding features.
Send firmware failed. A firmware download
operation failed.
Retry the firmware download
operation. If the problem persists,
contact the next level of support.
SNMP trap address not
defined.
If an SNMP community
name is defined, a
corresponding SNMP
trap recipient address
must also be defined.
Enter a corresponding SNMP trap
recipient address.
Table 31 Element Manager messages (continued)
Message Description Action