Usb step 2: plug in the power – HP Deskjet 832c Printer User Manual
Page 21
13
Setting Up Your Printer with a USB Cable
1
USB Step 2: Plug in the Power
1
Leave the computer and the printer turned off.
2
Lift open the cable access door on the back of the printer.
3
Plug the power adapter’s cord
firmly into the connector on the
back of the printer.
4
Plug the appropriate end of the
power cord into the power
adapter.
5
Plug the other end of the power
cord into an electrical outlet.
Note:
Do NOT connect your USB cable between the printer and the
computer. Make sure that the USB cable is NOT plugged into the computer at
this point in the setup procedure.
6410023
Note:
Use only the Power
button on the front of the printer to turn the
printer on and off. Using a power strip, surge protector or a wall outlet switch
to turn the printer on and off may cause premature failure.
dj895c.book Page 13 Monday, July 12, 1999 11:31 AM