HP Officejet Pro 8000 - A811 - Manual (Page 98)

3. Select the priority in which you want the rule to be used from the Rule Precedence list, with 1
having the highest priority and 10 having the lowest priority.
4. Click Apply.
Change firewall options
To change firewall options for the printer, complete the following steps:
1. Open the embedded Web server. For more information, see Embedded Web server.
2. Click the Settings tab, click Firewall Options.
3. Change any settings, and then click Apply.
NOTE: After clicking Apply, the connection to the EWS might be temporarily disrupted for a
short period of time. If the IP address was unchanged, the EWS connection will be enabled
again. However, if the IP address was changed, use the new IP address to open the EWS.
Reset firewall settings
To reset the firewall settings to the factory defaults, restore the printer’s network settings. For
more information, see To reset the printer's network settings.
Limitations to rules, templates, and services
When creating firewall rules, note the following limitations to rules, templates, and services.
Item Limit
Maximum number of rules. 11
Maximum number of Address Templates.
Note the following:
• All IP Addresses Results in two (2)
address template rules. One for all IPv4
addresses, and another for all IPv6
addresses.
• All non link local IPv6 Results in four (4)
address template rules:
ƕ
:: to
FE7F:FFFF:FFFF:FFFF:FFFF:FFFF:
FFFF:FFFF for both local and remote
addresses
ƕ :: to
FE7F:FFFF:FFFF:FFFF:FFFF:FFFF:
FFFF:FFFF for local addresses
ƕ FE81:: to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:
FFFF:FFFF for remote addresses
ƕ FE81:: to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:
FFFF:FFFF for local addresses,
12
Appendix C
94 Network setup