HP Officejet Pro 8000 - A811 - Manual (Page 99)

Item Limit
ƕ :: to
FE7F:FFFF:FFFF:FFFF:FFFF:FFFF:
FFFF:FFFF for remote addresses
ƕ FE81:: to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:
FFFF:FFFF for both local and remote
addresses
• All Broadcast/Multicast Addresses
Results in four (4) address template rules:
ƕ
224.0.0.0 to 239.255.255.255 IPv4
local addresses and all IPv4 remote
addresses
ƕ A single IPv4 local address, and all
IPv4 remote addresses
ƕ 255.255.255.255 local address, and
all IPv4 remote addresses
ƕ FF00:: / 8 local IPv6 addresses, and
all IPv6 remote addresses
NOTE: To avoid multiple rules for these
predefined address templates, you can create
custom address templates.
Maximum number of user-defined address
templates. 5
Maximum number of services you can add to
a user-defined service template.
NOTE: The predefined All Services template
is not subject to this limitation and includes all
services supported by the print server.
64
Maximum number of services you can add to
the policy.
For example, if a user-defined service
template consists of 64 services, then it is the
only service template you can use.
64
Maximum number of service templates in the
policy. 10
Maximum number of user-defined custom
service templates. 5
Reset network settings
To reset the administrator password and network settings, complete the following steps:
1. Press right arrow Graphic - Right arrow, and then select Network.
2. Press Restore Network Defaults, and then select Yes.
NOTE: Print the network configuration page and verify that the network settings have been
reset. For more information, see Understand the network configuration page.
By default, the network name (SSID) is “hpsetup” and the communication mode is “ad hoc.”
(continued)
Reset network settings 95