HP Photosmart Pro B8353 Printer - Manual (Page 56)

For Macintosh
1. Load the appropriate paper:
● If you are printing one or just a few sheets, you can use the front or rear manual feed slot. If
so, continue with the steps below and load the paper in a later step.
● If you are using the input tray, see Loading media in the input tray .
2. Open the file you wish to print.
3. Click File, and then click Page Setup.
4. Select the borderless paper size and click OK.
5. Click File, and then click Print.
6. Open the Paper Type/Quality panel.
7. Click the Paper tab and select the media type from the Paper type drop-down list.
8. If you are printing photos, under the Quality drop-down list, select Best. Alternatively, select
Maximum dpi, which provides up to 4800 x 1200 optimized dpi*.
*Up to 4800 x 1200 optimized dpi for color printing and 1200 input dpi. This setting might temporarily
use a large amount of hard disk space (400 MB or more) and will print slower. Photo cartridge, if
present, further enhances the print quality.
9. Select the paper source. If you are printing on thick or photo paper, select the manual feed option.
10. Change any other desired print settings and click Print.
11. If you are printing on thick or photo paper, insert paper into the rear manual feed slot at the back
of the printer. (For instructions on feeding paper manually, see
Printing with the front or rear manual
feed slot .)
12. If you printed on photo paper with a tear-off tab, remove the tab to make the document completely
borderless.
46 Chapter 4 Printing and loading media ENWW